Terminal Length Commands 174981Terminal Length CommandsDell Networking N2000/N3000/N4000 Series SwitchesThis chapter provides information about terminal length commands.terminal lengthUse the terminal length command to set the terminal length. Use the noform of the command to reset the terminal length to the default.Syntaxterminal lengthvalueno terminal length•value — The length in number of lines. Range: 0–512Default ConfigurationThis default value is 24.Command ModePrivileged EXEC modeUser GuidelinesSetting the terminal length to 0 disables paging altogether. It isrecommended that the terminal length either be set to 0 or a value larger than4 as terminal lengths in the range of 1 to 4 may give odd output due toprompting. The terminal length command is specific to the current session.Logging out, rebooting or otherwise ending the current session will requirethat the command be reentered. Likewise, because the terminal lengthsetting is specific to a session, it is never saved in the config.Exampleconsole#terminal length 50
