408 Ethernet Configuration CommandsSyntaxstorm-control unicast [level |rate]no storm-control unicast• level— The configured rate as a percentage of link-speed.•rate — The configured rate in kilobits per second (Kbps). (Range: 0-100)Default ConfigurationThe default value is 5.Command ModeInterface Configuration (Ethernet) modeUser GuidelinesThis command has no user guidelines.Exampleconsole(config-if-Gi1/0/1)#storm-control unicast level 5switchport protectedUse the switchport protected command in Interface Configuration mode toconfigure a protected port. Thegroupid parameter identifies the set ofprotected ports to which this interface is assigned. You can only configure aninterface as protected in one group. You are required to remove an interfacefrom one group before adding it to another group.Port protection occurs within a single switch. Protected port configurationdoes not affect traffic between ports on two different switches. No trafficforwarding is possible between two protected ports. Ports in a protected groupwill not forward traffic to other ports in the group.Syntaxswitchport protectedgroupidno switchport protected•groupid--Identifies which group this port will be protected in. (Range: 0-2)
