Operation Manual – VLANH3C S7500 Series Ethernet Switches Chapter 2 VLAN Configuration2-3To do… Use the command… RemarksDisable the VLANinterface shutdown OptionalEnable the VLANInterface undo shutdown OptionalNote that the operation of enabling/disabling a VLAN interface does not influence theenabling/disabling status of the Ethernet ports belonging to this VLAN.By default, a VLAN interface is enabled. In this scenario, the VLAN interface’s status isdetermined by the status of its ports, that is, if all ports of the VLAN are down, the VLANinterface is down (disabled); if one or more ports of the VLAN are up, the VLANinterface is up (enabled).If a VLAN interface is disabled, its status is not determined by the status of its ports.2.1.4 Displaying VLAN ConfigurationTo do… Use the command… RemarksDisplay the VLANinterface informationdisplay interface Vlan-interface[ vlan-id ]Display the VLANinformationdisplay vlan [ vlan-id [ to vlan-id ] |all | static | dynamic ]Available in anyview.2.2 Configuring a Port-Based VLAN2.2.1 Configuring an Access-Port-Based VLANThere are two ways to configure Access-port-based VLAN: one way is to configure inVLAN view, the other way is to configure in Ethernet port view.Follow these steps to configure the Access-port-based VLAN in VLAN view:To do… Use the command… RemarksEnter system view system-view —Enter VLAN view vlan vlan-idRequiredIf the specified VLAN does notexist, this command be createdfirst creates the VLAN beforeentering its view.Add an Access portto the current VLAN port interface-listRequiredBy default, system will add allports to VLAN 1.
