Operation Mannual – RRPPH3C S7500 Series Ethernet Switches Chapter 1 RRPP Configuration1-13To do… Use the command… RemarksDisplay the briefinformation of all RRPPdomains configured onthe switchdisplay rrpp briefDisplay RRPPconfiguration details onthe switchdisplay rrpp verbosedomain domain-id [ ringring-id ]Display the RRPP packetstatistics on the switchdisplay rrpp statisticsdomain domain-id [ ringring-id ]Optional.You can execute thedisplay command in anyviewTo clear the RRPP statistics, use the reset rrpp statistics domain domain-id [ ringring-id ] command.Caution:z The control VLAN of an RRPP domain cannot be a static VLAN already created onthe switch. If you configure a dynamic VLAN as the control VLAN of an RRPPdomain, the VLAN becomes a static VLAN automatically.z You are not recommended to configure a VLAN as both an RRPP control VLAN anda remote-probe VLAN. (Refer to Mirroring part of this manual for information aboutremote-probe VLAN.)z You are not recommended to configure a VLAN as both an RRPP control VLAN andan isolate-user-VLAN/sub VLAN. (Refer to Extended VLAN Application part of thismanual for information about isolate-user-VLAN and sub VLAN.)z Before creating an RRPP ring, you need to create the control VLAN.z When deleting an RRPP domain by using the undo rrpp domain command, makesure no RRPP ring exists in the RRPP domain.z The ring IDs of different rings in the same RRPP domain cannot be the same.1.4.2 Edge Node Configuration ExampleI. Network requirementsz Define the switch as a node in RRPP domain 1.z Define VLAN 4092 as the control VLAN.z Define the switch as a transit node on primary ring 1 in RRPP domain 1,GigabitEthernet 2/0/1 as the primary port, and GigabitEthernet 2/0/2 as thesecondary port.
