Operation Manual – MirroringH3C S7500 Series Ethernet Switches Chapter 1 Mirroring Configuration1-7IV. Configuration Examplez The source port is GigabitEthernet 2/0/1. Mirror all packets received and sent viathis port.z The destination port is GigabitEthernet 2/0/4.1) Configuration procedure 1: system-view[H3C] mirroring-group 1 local[H3C] interface GigabitEthernet 2/0/4[H3C-GigabitEthernet2/0/4] mirroring-group 1 monitor-port[H3C-GigabitEthernet2/0/4] quit[H3C] interface GigabitEthernet 2/0/1[H3C-GigabitEthernet2/0/1] mirroring-group 1 mirroring-port both2) Configuration procedure 2: system-view[H3C] mirroring-group 1 local[H3C] mirroring-group 1 monitor-port GigabitEthernet 2/0/4[H3C] mirroring-group 1 mirroring-port GigabitEthernet 2/0/1 both1.3.2 Configuring Remote Port MirroringI. Configuration prerequisitesz The source switch, intermediate switch, and the destination switch have beendetermined.z The source port, the reflector port, the destination port, and the remote-probeVLAN have been determined.z Required configurations are performed to ensure Layer 2 connectivity between thesource and destination switches over the remote-probe VLAN.z The direction of the packets to be monitored has been determined.z The remote-probe VLAN is enabled.II. Configuring remote port mirroring on the source switchTo do… Use the command… RemarksEnter system view system-view —Create a VLAN and enterits VLAN view vlan vlan-idvlan-id is the ID of thedestination remote-probeVLAN.Define the current VLANas a remote-probe VLANremote-probe vlanenable RequiredExit current view quit —
