Operation Manual – Port Basic ConfigurationH3C S7500 Series Ethernet Switches Chapter 1 Port Basic Configuration1-1Chapter 1 Port Basic ConfigurationWhen configuring port basic configuration, go to these sections for information you areinterested in:z Ethernet Port Configurationz Ethernet Port Configuration Examplez Troubleshooting Ethernet Port Configuration1.1 Ethernet Port Configuration1.1.1 Initially Configuring a PortTo do… Use the command… RemarksEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —Enable the Ethernetport undo shutdownOptionalBy default, the port is enabled.Use the shutdown commandto disable the port.Set the descriptionof the Ethernet port description textOptionalBy default, no description isdefined for the port.Set the duplex modeof the Ethernet port duplex { auto | full | half }OptionalBy default, the duplex mode ofthe port is auto(auto-negotiation).Set the speed of theEthernet portspeed { 10 | 100 | 1000 |10000 | auto }OptionalBy default, the speed of theport is auto (auto-negotiation).Set the mediumdependent interface(MDI) attribute of theEthernet portmdi { across | auto |normal }OptionalBe default, the MDI attribute ofthe port is auto.Allow jumbo framesto pass through theEthernet portjumboframe enable[ jumboframe-value ]OptionalBy default, jumbo frames thatare larger than 1518 bytes andsmaller than 1536 bytes areallowed to pass through theport.
