Operation Manual – Information CenterH3C S7500 Series Ethernet Switches Chapter 1 Information Center1-7To do... Use the command... RemarksEnable information outputto a log hostinfo-center loghosthost-ip-addr [ channel{ channel-number |channel-name } | facilitylocal-number | language{ chinese | english } ]*RequiredBy default, the switchdoes not outputinformation to the loghost.After you configure theswitch to outputinformation to the loghost, the switch usesinformation channel 2 bydefault.Be sure to set the correctIP address. A loopback IPaddress will cause anerror message promptingan invalid address.Configure the sourceinterface through whichlog information is sent tothe log hostinfo-center loghostsource interface-typeinterface-numberOptionalDefine an informationsourceinfo-center source{ modu-name | default }channel{ channel-number |channel-name } [ { log |trap | debug } * { levelseverity | state state } ]*RequiredSet the format of the timestampinfo-center timestamp{ log | trap | debugging }{ boot | date | none }OptionalNote:To view the debugging information of specific modules, you need to set the informationtype to debug in the info-center source command, and enable debugging forcorresponding modules through the debugging command.1.2.2 Enabling Information Output to the ConsoleFollow these steps to enable information output to the console:
