Operation Manual – Information CenterH3C S7500 Series Ethernet Switches Chapter 1 Information Center1-14To do... Use the command... RemarksClear information recorded in logbuffer reset logbufferClear information recorded in trapbuffer reset trapbufferAvailablein userview1.4 Information Center Configuration Examples1.4.1 Log Output to a Unix Log HostI. Network requirementsThe switch sends the following log information in English to the Unix log host whose IPaddress is 202.38.1.10: the log information of the two modules ARP and IP, with aseverity higher than “informational”.II. Network diagramNetworkPCSwitchtFigure 1-1 Network diagram for log output to a Unix log hosIII. Configuration procedure1) Configure the switch:# Enable the information center. system-view[H3C] info-center enable# Disable for all modules the function of outputting information to log host channels.[H3C] undo info-center source default channel loghost# Configure the host whose IP address is 202.38.1.10 as the log host. Set the outputlanguage to English. Permit ARP and IP modules to output information with a severityhigher than “informational” to the log host.[H3C] info-center loghost 202.38.1.10 facility local4 language english[H3C] info-center source arp channel loghost log level informational debugstate off trap state off[H3C] info-center source ip channel loghost log level informational debug stateoff trap state off2) Configure the log host:
