Operation Mannual – RRPPH3C S7500 Series Ethernet Switches Chapter 1 RRPP Configuration1-14z Define the switch as an edge node on subring 2 in RRPP domain 1, the portGigabitEthernet 2/0/2 as the common port, the port GigabitEthernet 2/0/4 as theedge port.II. Configuration procedure system-view[H3C] rrpp domain 1[H3C-rrpp-domain1] control-vlan 4092[H3C-rrpp-domain1] ring 1 node-mode transit primary-port GigabitEthernet2/0/1secondary-port GigabitEthernet2/0/2 level 0[H3C-rrpp-domain1] ring 2 node-mode edge common-port GigabitEthernet 2/0/2edge-port GigabitEthernet 2/0/4[H3C-rrpp-domain1] ring 1 enable[H3C-rrpp-domain1] ring 2 enable[H3C-rrpp-domain1] quit[H3C] rrpp enable[H3C] display rrpp brief[H3C] display rrpp verbose domain 1[H3C] display rrpp statistics domain 11.5 Assistant Edge Node Configuration1.5.1 Assistant Edge Node Configuration TasksFollow these steps to configure an assistant edge node:To do… Use the command… RemarksEnter system view system-view —Create an RRPP domain,and enter RRPP domainviewrrpp domain domain-idRequired.The command prompt ofRRPP domain viewdepends on the domain-idyou input.Specify a control VLANfor the RRPP domain control-vlan vlan-id RequiredSpecify the currentswitch as a transit nodeof the primary ring, andspecify the primary portand the secondary portring ring-id node-modetransit [ primary-portpri-port ] [ secondary-portsec-port ] level level-valueRequired.Level 0 identifies theprimary ring and level 1identifies a subring.Specify the currentswitch as an assistantedge node of the subring,and specify a commonport and an edge portring ring-id node-modeassistant-edge[ common-portcomm-port ] [ edge-portedge-port ]Required
