Operation Manual – System Maintenance and DebuggingH3C S7500 Series Ethernet Switches Chapter 4 Device Management4-114.7 Displaying the Device Management ConfigurationAfter the above configurations, you can execute the display command in any view todisplay the operating status of the device management to verify the configurationeffects.Follow these steps to display the operating status of the device management:To do… Use the command… RemarksDisplay the APP to be adoptedat reboot display boot-loaderDisplay the module type andoperating status of each boarddisplay device [ detail | [ shelfshelf-no ] [ frame frame-no ] [ slotslot-number ] ]Display information aboutenvironment used by a switch display environmentDisplay the operating status ofthe built-in fan display fan [ fan-id ]Display the usage of s switch display cpu [ slot slot-number ]Display memory usage of aswitchdisplay memory [ slot slot-number| limit ]Display the operating status ofthe power supply display power [ power-id ]Available inany view.4.8 Remote Switch Update Configuration ExampleI. Network requirementsTelnet to the switch from a PC remotely and download applications from the FTP serverto the Flash memory of the switch to remotely update the switch software by using thedevice management commands through CLI.The switch acts as the FTP client, and the remote PC serves as both the configurationPC and the FTP server.Perform the following configuration on the FTP server.z Configure an FTP user, whose name and password are switch and hellorespectively. Authorize the user with the read-write right of the Switch directory onthe PC.z Make appropriate configuration so that the IP address of a VLAN interface on theswitch is 1.1.1.1, the IP address of the PC is 2.2.2.2, and the switch and the PC isreachable to each other.
