Operation Manual – MirroringH3C S7500 Series Ethernet Switches Chapter 1 Mirroring Configuration1-13reflector port: GigabitEthernet2/0/3remote-probe vlan: 10# Configure Switch B. system-view[H3C] vlan 10[H3C-vlan10] remote-probe vlan enable[H3C-vlan10] quit[H3C] interface GigabitEthernet 2/0/1[H3C-GigabitEthernet2/0/1] port link-type trunk[H3C-GigabitEthernet2/0/1] port trunk permit vlan 10[H3C-GigabitEthernet2/0/1] quit[H3C] interface GigabitEthernet 2/0/2[H3C-GigabitEthernet2/0/2] port link-type trunk[H3C-GigabitEthernet2/0/2] port trunk permit vlan 10# Configure Switch A. system-view[H3C] vlan 10[H3C-vlan10] remote-probe vlan enable[H3C-vlan10] quit[H3C] interface GigabitEthernet 2/0/1[H3C-GigabitEthernet2/0/1] port link-type trunk[H3C-GigabitEthernet2/0/1] port trunk permit vlan 10[H3C-GigabitEthernet2/0/1] quit[H3C] mirroring-group 1 remote-destination[H3C] mirroring-group 1 monitor-port GigabitEthernet 2/0/2[H3C] mirroring-group 1 remote-probe vlan 10[H3C] display mirroring-group remote-destinationmirroring-group 1:type: remote-destinationstatus: activemonitor port: GigabitEthernet2/0/2remote-probe vlan: 101.3.3 Configuring Traffic MirroringI. Configuration prerequisitesz ACLs for identifying traffics have been defined. For defining ACLs, see thedescription on the ACL module in this manual.z The destination port has been defined.z The port on which to perform traffic mirroring configuration and the direction oftraffic mirroring has been determined.
