Operation Mannual – RRPPH3C S7500 Series Ethernet Switches Chapter 1 RRPP Configuration1-9To do… Use the command… RemarksReturn to systemview quit —Enable the RRPPprotocol rrpp enable RequiredDisplay the briefinformation of allRRPP domainsconfigured on theswitchdisplay rrpp briefDisplay RRPPconfiguration detailson the switchdisplay rrpp verbosedomain domain-id [ ringring-id ]Display RRPP packetstatistics of the switchdisplay rrpp statisticsdomain domain-id [ ringring-id ]Optional.You can execute thedisplay command in anyviewTo clear the RRPP statistics, use the reset rrpp statistics domain domain-id [ ringring-id ] command.Caution:z The control VLAN of an RRPP domain cannot be a static VLAN already created onthe switch. If you configure a dynamic VLAN as the control VLAN of an RRPPdomain, the VLAN becomes a static VLAN automatically.z You are not recommended to configure a VLAN as both an RRPP control VLAN anda remote-probe VLAN. (Refer to Mirroring part of this manual for information aboutremote-probe VLAN.)z You are not recommended to configure a VLAN as both an RRPP control VLAN andan isolate-user-VLAN/sub VLAN. (Refer to Extended VLAN Application part of thismanual for information about isolate-user-VLAN and sub VLAN.)z Before creating an RRPP ring, you need to create the control VLAN.z When deleting an RRPP domain by using the undo rrpp domain command, makesure no RRPP ring exists in the RRPP domain.1.2.2 Master Node Configuration ExampleI. Network requirementsz Define the switch as a node in RRPP domain 1z Define VLAN 4092 as the control VLAN
