Operation Manual – ClusterH3C S7500 Series Ethernet Switches Chapter 1 Cluster1-9To do… Use the command… RemarksEnter system view system-view —Enable the clusterfunction globally cluster enableOptionalBy default, the cluster function isenabled1.2.7 Configuring Cluster ParametersI. Creating a cluster and configuring cluster parameters manuallyFollow these steps to configure cluster parameters manually:To do… Use the command… RemarksEnter system view system-view —Enter VLAN interface view interface Vlan-interfacevlan-idRequiredYou are required toconfigure the IP addressof the Layer 3 virtualinterface of VLAN 1before you set up acluster. Otherwise, thecluster cannot be set up.Configure the IP addressof the VLAN interfaceip address ip-address{ mask | mask-length } RequiredEnter cluster view cluster —Configure an IP addresspool for the clusterip-pooladministrator-ip-address{ ip-mask |ip-mask-length }RequiredBuild a cluster build nameOptionalThe name argumentindicates the name to beassigned.Configure the holdtime fora switch holdtime secondsOptionalBy default, the holdtime is60 secondsSet the interval to sendhandshake packets timer intervalOptionalBy default, the interval tosend handshake packetsis 10 secondsQuit cluster view quit —
