Operation Mannual – RRPPH3C S7500 Series Ethernet Switches Chapter 1 RRPP Configuration1-161.5.2 Assistant Edge Node Configuration ExampleI. Network requirementsz Define the switch as a node in RRPP domain 1.z Define VLAN 4092 as the control VLAN.z Define the switch as a transit node in primary ring 1 in RRPP domain 1, the portGigabitEthernet 2/0/1 as the primary port, the port GigabitEthernet 2/0/2 as thesecondary port.z Define the switch as an assistant edge node on subring 2 in the RRPP domain 1,the port GigabitEthernet 2/0/2 as the common port, and the port GigabitEthernet2/0/4 as the edge port.II. Configuration procedure system-view[H3C] rrpp domain 1[H3C-rrpp-domain1] control-vlan 4092[H3C-rrpp-domain1] ring 1 node-mode transit primary-port GigabitEthernet2/0/1secondary-port GigabitEthernet2/0/2 level 0[H3C-rrpp-domain1] ring 2 node-mode assistant-edge common-portGigabitEthernet 2/0/2 edge-port GigabitEthernet 2/0/4[H3C-rrpp-domain1] ring 1 enable[H3C-rrpp-domain1] ring 2 enable[H3C-rrpp-domain1] quit[H3C] rrpp enable[H3C] display rrpp brief[H3C] display rrpp verbose domain 1[H3C] display rrpp statistics domain 11.6 Configuration Examples1.6.1 Single Ring Network Configuration ExampleI. Network requirementsz Switch A, Switch B, Switch C and Switch D constitute RRPP domain 1.z VLAN 4092 is the control VLAN of RRPP domain 1.z Switch A, Switch B, Switch C and Switch D constitute primary ring 1.z Switch A serves as the master node of the primary ring, its GigabitEthernet 2/0/1 isthe primary port, and GigabitEthernet 2/0/2 is the secondary port.z Switch B, Switch C and Switch D are transit nodes of the primary ring. Theirrespective GigabitEthernet 2/0/1 and GigabitEthernet 2/0/2 serve as the primaryand secondary ports.z The default values are used for the timers on the primary ring.
