Operation Manual – 802.1xH3C S7500 Series Ethernet Switches Chapter 2 HABP Configuration2-2To do... Use the command... RemarksConfigure thecurrent switch to bean HABP serverhabp server vlanvlan-idRequiredBy default, a switch operates asan HABP client after you enableHABP on the switch, and if youwant to use the switch as amanagement switch, you mustconfigure the switch to be anHABP server.Configure theinterval to sendHABP requestpacketshabp timer interval Optional20 seconds by default2.3 HABP Client ConfigurationHABP clients reside on the switches attached to the HABP server. After you enableHABP on a switch, the switch operates as an HABP client by default. So you only needto enable HABP on a switch.Table 2-2 Configure an HABP clientTo do... Use the command... RemarksEnter system view system-view —Enable HABP habp enableOptionalEnabled by defaultA switch operates as an HABP clientafter you enable HABP on it.2.4 Displaying HABPAfter performing the above configuration, you can display and verify HABPconfiguration by executing the display command in any view.Table 2-3 Display HABPTo do... Use the command... RemarksDisplay information about HABPconfiguration and status display habpDisplay information about the MACaddress table maintained by HABP display habp tableDisplay statistics of HABP packets display habp trafficIn any view
