Operation Manual – IP Address-IP Performance-IPXH3C S7500 Series Ethernet Switches Chapter 3 IPX Configuration3-10To do… Use the command… RemarksConfigure an IPX networknumber for the VLANinterfaceipx network networkRequiredBy default, the systemdoes not assign networknumbers to VLANinterface. That is, IPX isdisabled on all the VLANinterfaces.Enable triggered updateof IPX ipx update-change-onlyOptionalBy default, triggeredupdate of IPX is disabled.Enable split horizon of IPX ipx split-horizonOptionalBy default, split-horizon isenabled.Configure theencapsulation format ofthe IPX frameipx encapsulation [ dot2| dot3 | ethernet-2 |snap ]OptionalBy default, theencapsulation format ofthe IPX frame is 802.3(dot3)Enable the forwarding ofType 20 broadcastpacketsipx netbios-propagationOptionalBy default, Type 20broadcast packets are notforwarded.3.3 Displaying and Maintaining IPX ConfigurationTo do… Use the command… RemarksView the information ofIPX on the VLAN interfacedisplay ipx interface [ Vlan-interfacevlan-id ]View the IP packetstatistics display ipx statisticsView the IPX serviceinformation tabledisplay ipx service-table [ inactive |name name | network network | order{ network | type } | type service-type ][ verbose ]View the IPX routinginformationdisplay ipx routing-table [ network[ verbose ] | protocol { default | direct |rip | static } [ inactive | verbose ] |statistics | verbose ]Available inany viewClear the IPX statistics reset ipx statisticsClear the IPX routing tableinformationreset ipx routing-table statisticsprotocol { all | default | direct | rip |static }Available inuser view
