Operation Manual – System Maintenance and DebuggingH3C S7500 Series Ethernet SwitchesChapter 1 Boot ROM and Host SoftwareLoading1-12Prepare for loading...OK!Loading........................................doneBootrom updating..........done!z Loading host softwareFollow these steps to load the host software:Step 1: Select <1> in Boot Menu and press . The system displays the followinginformation:1. Set TFTP protocol parameter2. Set FTP protocol parameter3. Set XMODEM protocol parameter0. Return to boot menuEnter your choice(0-3):Enter 2 in the above menu to download the host software using FTP.The subsequent steps are the same as those for loading the Boot ROM program,except for that the system gives the prompt for host software loading instead of BootROM loading.Caution:When loading Boot ROM and host software using Boot menu, you are recommended touse the PC directly connected to the device as TFTP server to promote upgradingreliability.1.3 Remote Software LoadingIf your terminal is not directly connected to the switch, you can telnet to the switch, anduse FTP or TFTP to load Boot ROM and host software remotely.1.3.1 Remote Loading Using FTPI. Loading Process Using FTP Client1) Loading Boot ROMAs shown in Figure 1-8, a PC is used as both the configuration device and the FTPserver. You can telnet to the switch, and then execute the FTP commands to downloadthe Boot ROM program s7500.btm from the remote FTP server (with an IP address10.1.1.1) to the switch.
