Operation Manual – Port Basic ConfigurationH3C S7500 Series Ethernet Switches Chapter 1 Port Basic Configuration1-6To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Enable the system to test thecable connected to the port virtual-cable-test Required1.1.7 Configuring the Interval to Perform Statistical Analysis on Port TrafficBy performing the following configuration, you can set the interval to perform statisticalanalysis on the traffic of a port.When you use the display interface interface-type interface-number command todisplay the information of a port, the system displays the average rates of the traffic flowpassing through the port during the specified interval. For example, if you set thisinterval to 100 seconds, the displayed information is as follows:Last 100 seconds input: 0 packets/sec 0 bytes/secLast 100 seconds output: 0 packets/sec 0 bytes/secFollow these steps to set the interval to perform statistical analysis on port traffic:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Set the interval to performstatistical analysis on porttrafficflow-interval intervalOptionalBy default, this interval is300 seconds.1.1.8 Setting Speedup for a PortFollow these steps to set speedup for a port:To do… Use the command… RemarksEnter system view system-view —Enable the hardwarespeedup function insidethe porthardspeedup enableDisable the hardwarespeedup function insidethe porthardspeedup disableOptionalBy default, the hardwarespeedup function insidethe port is enabled.
