Operation Manual – IP Address-IP Performance-IPXH3C S7500 Series Ethernet Switches Chapter 3 IPX Configuration3-113.4 IPX Configuration ExampleI. Network requirementsThrough an IPX network, Switch A with a node address of 000f-e20f-0000 is connectedto Switch B with a node address of 000f-e20f-0001.There is a server installed with NetWare 4.1 and assigned a network number of 2. Onthe server, the packet encapsulation format is set to Ethernet_II. The client is a PC witha network number of 3 and a packet encapsulation format of SNAP. The serverprovides file service and printing service. The client accesses the file and printingservices provided by the server through the IPX network. The node address of theserver is 0000-0c91-f61f.II. Network diagramIPXVlan -int11000.000f-e20 f-0000Vlan -int22 .000f-e 20f-0000Switch AServerVl3 .000 f-e 2Vlan- int11000 .000 f-e 20f-0001Switch BClientan-int20f-0001Figure 3-1 IPX network diagramIII. Configuration procedure1) Configure Switch A.# Enable IPX. system-view[H3C] ipx enable# Assign the network number 2 to VLAN interface 2 and enable IPX on the VLANinterface.[H3C] interface Vlan-interface 2[H3C-Vlan-interface2] ipx network 2# Set the packet encapsulation format to Ethernet_II on VLAN interface 2.[H3C-Vlan-interface2] ipx encapsulation ethernet-2
