Operation Manual – Port Basic ConfigurationH3C S7500 Series Ethernet Switches Chapter 1 Port Basic Configuration1-4To do… Use the command… RemarksEnter Ethernet port view interface interface-typeinterface-number —Enable flow control on theEthernet port flow-controlRequiredBy default, flow control isdisabled on a port.1.1.4 Copying the Configuration of a Port to Other PortsTo make some other ports have the same configuration as that of a specific port, youcan copy the configuration of the specific port to the ports by using the copyconfiguration command.The following types of port configuration can be copied from one port to other ports:VLAN configuration, protocol-based VLAN configuration, LACP configuration, QoSconfiguration, STP configuration and initial port configuration.z VLAN configuration: IDs of the VLANs allowed on the port and the default VLAN IDof the port;z Protocol-based VLAN configuration: IDs and indexes of the protocol-basedVLANs allowed on the port;z Link aggregation control protocol (LACP) configuration: LACP enabled/disabledstatus;z QoS configuration: rate limit, port priority, and default 802.1p priority on the port;z STP configuration: STP enabled/disabled status on the port, link attribute on theport (point-to-point or non-point-to-point), STP priority, path cost, packettransmission rate limit, whether loop guard is enabled, whether root guard isenabled, and whether the port is an edge port;z Port configuration: link type of the port, port speed and duplex mode.Follow these steps to copy the configuration of a port to other ports:To do… Use the command… RemarksEnter system view system-view —Copy theconfiguration of aport to other portscopy configuration source { interface-typeinterface-number | aggregation-groupsource-agg-id } destination { interface-list[ aggregation-group destination-agg-id ] |aggregation-group destination-agg-id }Required
