Operation Mannual – RRPPH3C S7500 Series Ethernet Switches Chapter 1 RRPP Configuration1-10z Define the switch as the master node on primary ring 1 in RRPP domain 1,GigabitEthernet2/0/1 as the primary port, and GigabitEthernet2/0/2 as thesecondary port.z Set the Hello timer and Fail time to 2 seconds and 7 seconds respectively.II. Configuration procedure system-view[H3C] rrpp domain 1[H3C-rrpp-domain1] control-vlan 4092[H3C-rrpp-domain1] ring 1 node-mode master primary-port GigabitEthernet2/0/1secondary-port GigabitEthernet2/0/2 level 0[H3C-rrpp-domain1] timer hello-timer 2 fail-timer 7[H3C-rrpp-domain1] ring 1 enable[H3C-rrpp-domain-1] quit[H3C] rrpp enable[H3C] display rrpp brief[H3C] display rrpp verbose domain 1[H3C] display rrpp statistics domain 11.3 Transit Node Configuration1.3.1 Transit Node Configuration TasksFollow these steps to configure a transit node:To do… Use the command… RemarksEnter system view system-view —Create an RRPPdomain, and enterRRPP domain viewrrpp domain domain-idRequired.The command prompt ofRRPP domain viewdepends on the domain-idyou input.Specify a control VLANfor the RRPP domain control-vlan vlan-id RequiredSpecify the currentswitch as the transitnode of a ring, andspecify the primary portand the secondary portof the nodering ring-id node-modetransit [ primary-portpri-port ][ secondary-portsec-port ] levellevel-valueRequired.Level 0 identifies the primaryring and level 1 identifies asubring.Enable an RRPP ring ring ring-id enable RequiredReturn to system view quit —Enable RRPP rrpp enable Required
