Operation Manual – AAA & RADIUS & HWTACACS & EADH3C S7500 Series Ethernet SwitchesChapter 1 AAA & RADIUS & HWTACACSConfiguration1-28To do... Use the command... RemarksSet the status of theprimary RADIUSauthentication/authorization serverstate primaryauthentication { block |active }Set the status of theprimary RADIUSaccounting serverstate primaryaccounting { block |active }Set the status of thesecondary RADIUSauthentication/authorization serverstate secondaryauthentication { block |active }Set the status of thesecondary RADIUSaccounting serverstate secondaryaccounting { block |active }OptionalBy default, all the RADIUSservers in a customizedRADIUS scheme are inthe block state, and allthe RADIUS serversconfigured with IPaddresses are in theactive state.1.4.8 Configuring the Attributes for Data to be Sent to RADIUS ServersTable 1-19 Configure the attributes for data to be sent to the RADIUS serversTo do... Use the command... RemarksEnter system view system-view —Create a RADIUS schemeand enter its viewradius schemeradius-scheme-nameRequiredBy default, a RADIUSscheme named systemhas already been createdin the system.Set the format of the usernames to be sent toRADIUS serversuser-name-format{ with-domain |without-domain }OptionalBy default, the usernames sent from theswitch to RADIUS serverscarry ISP domain names.Set the units of measurefor data flows sent toRADIUS serversdata-flow-format data{ byte | giga-byte |kilo-byte | mega-byte }packet { giga-packet |kilo-packet | mega-packet | one-packet }OptionalBy default, in a RADIUSscheme, the unit ofmeasure for data is byteand that for packets isone-packet.RADIUS scheme viewnas-ip ip-addressSet the source IP addressused by the switch to sendRADIUS packets System viewradius nas-ip ip-addressOptionalBy default, no source IPaddress is specified; andthe IP address of theoutbound interface isused as the source IPaddress.
