Operation Manual – Routing ProtocolH3C S7500 Series Ethernet Switches Chapter 6 BGP Configuration6-7Task RemarksConfiguring Basic BGP Functions RequiredImporting Routes OptionalConfiguring BGP Route Aggregation OptionalEnabling Default Route Advertising OptionalConfiguring the BGP Route AdvertisingPolicy OptionalConfiguring BGP Route Receiving Policy OptionalConfiguring BGP-IGP RouteSynchronization OptionalConfiguring BGP Route Dampening OptionalConfiguring theWay toAdvertise/Receive RoutingInformationConfiguring BGP Load Balance RequiredConfiguring BGP Route Attributes OptionalAdjusting and Optimizing a BGP Network OptionalConfiguring a BGP Peer Group RequiredConfiguring a BGP Community RequiredConfiguring BGP RR OptionalConfiguring aLarge-ScaleBGP NetworkConfiguring BGP Confederation Optional6.3 Basic BGP Configuration6.3.1 Configuration PrerequisitesBefore performing basic BGP configuration, you need to ensure:z Network layer connectivity between adjacent nodes.Before performing basic BGP configuration, make sure the following are available.z Local AS number and router IDz IPv4 address and AS number of the peersz Source interface of update packets.6.3.2 Configuring Basic BGP FunctionsFollow these steps to configure basic BGP functions:To do... Use the command... RemarksEnter system view system-view —Specify the router ID router id router-id Optional
