Operation Manual – QoSH3C S7500 Series Ethernet Switches Chapter 1 QoS Configuration1-23Note:z Only non-type-A LPUs support the traffic redirect configuration.z In a traffic redirect configuration, the source port and the destination port must be onthe same LPU.z The redirect configuration is effective only for ACL rules defined with the permitkeyword specified.z When packets are redirected to the CPU, they cannot be forwarded normally.1.8.3 Configuration Examplez A switch is connected to 10.1.1.1/24 network segment through its Ethernet 2/0/1port.z Redirect all the traffic from the 10.1.1.1/24 network segment to GigabitEthernet2/0/7.Configuration procedure: system-view[H3C] acl number 2000[H3C-acl-basic-2000] rule permit source 10.1.1.1 0.0.0.255[H3C-acl-basic-2000] quit[H3C] interface GigabitEthernet2/0/1[H3C-GigabitEthernet2/0/1] qos[H3C-qosb-GigabitEthernet2/0/1] traffic-redirect inbound ip-group 2000interface GigabitEthernet 2/0/71.9 Configuring Queue SchedulingRefer to Queue Scheduling for the introduction to queue scheduling.1.9.1 Configuration Prerequisitesz The queue-scheduling algorithm is specified.z The ports that need this configuration are specified.1.9.2 Configuration ProcedureFollow these steps to configure queue scheduling:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet portviewinterface interface-typeinterface-number —
