Operation Manual – AAA & RADIUS & HWTACACS & EADH3C S7500 Series Ethernet SwitchesChapter 1 AAA & RADIUS & HWTACACSConfiguration1-31Table 1-21 Set the timers of RADIUS serverTo do... Use the command... RemarksEnter system view system-view —Create a RADIUSscheme and enter itsviewradius schemeradius-scheme-nameRequiredBy default, a RADIUS schemenamed system has alreadybeen created in the system.timer response-timeoutsecondsSet the responsetimeout time ofRADIUS servers timer secondsOptionalBy default, the responsetimeout timer of RADIUSservers expires in threeseconds.Set the wait time forthe primary server torestore the activestatetimer quiet minutesOptionalBy default, the primary serverwaits five minutes beforerestoring the active state.Set the real-timeaccounting intervaltimerrealtime-accountingminutesOptionalBy default, the real-timeaccounting interval is 12minutes.1.4.11 Configuring the User Re-Authentication upon Device Restart FunctionNote:The function applies to the environment where the RADIUS authentication/accountingserver is CAMS.In an environment with a CAMS server, if the switch reboots after an exclusive user (auser whose concurrent online number is set to 1 on the CAMS) gets authenticated andauthorized and begins being charged, the CAMS will give a prompt that the user hasalready been online when the user re-logs in to the switch before CAMS performsonline user detection, and the user cannot get authenticated. In this case, the user canaccess the network again only after the CAMS administrator manually removes theonline information of the user.The user re-authentication upon device restart function is designed to resolve theabove problem. After this function is enabled, every time the switch restarts:
