Operation Manual – AAA & RADIUS & HWTACACS & EADH3C S7500 Series Ethernet SwitchesChapter 1 AAA & RADIUS & HWTACACSConfiguration1-241.4.3 Configuring RADIUS Accounting ServersTable 1-14 Configure RADIUS accounting serverTo do... Use the command... RemarksEnter system view system-view —Create a RADIUS schemeand enter its viewradius schemeradius-scheme-nameRequiredBy default, a RADIUSscheme named systemhas already been createdin the system.Set the IP address andport number of theprimary RADIUSaccounting serverprimary accountingip-address [ port-number ]RequiredBy default, the IP addressand UDP port number ofthe primary accountingserver are 0.0.0.0 and1813.Set the IP address andport number of thesecondary RADIUSaccounting serversecondary accountingip-address [ port-number ]OptionalBy default, the IP addressand UDP port number ofthe secondary accountingserver are 0.0.0.0 and1813.Enable stop-accountingpacket bufferingstop-accounting-bufferenableOptionalBy default,stop-accounting packetbuffering is enabled.Set the maximum numberof transmission attemptsof the bufferedstop-accounting packets.retry stop-accountingretry-timesOptionalBy default, the systemtries at most 500 times totransmit a bufferedstop-accounting request.Set the maximum numberof real-time accountingrequest attemptsretryrealtime-accountingretry-timesOptionalBy default, the maximumnumber of real-timeaccounting requestattempts is 5. After thisnumber is reached, theuser connection is cutdown.
