Operation Manual – IP Address-IP Performance-IPXH3C S7500 Series Ethernet Switches Chapter 3 IPX Configuration3-3To do… Use the command… RemarksConfigure an IPXnetwork number forthe VLAN interfaceipx network networkRequiredBy default, the system does notassign network numbers to VLANinterfaces. That is, IPX is disabledon all VLAN interfaces.Note:z After the undo ipx enable command is executed, the IPX configurations areremoved and cannot be recovered using the ipx enable command.z After IPX is enabled, you must assign a network number to a VLAN interface toenable IPX on this VLAN interface. One network number can be assigned to onlyone VLAN interface.z If the IPX network number of a VLAN interface is deleted, the IPX configuration andstatic routing information of this VLAN interface will be deleted at the same time.3.2.3 Configuring IPX RoutingI. Configuring IPX static routesFollow these steps to configure IPX static routes:To do… Use the command… RemarksEnter system view system-view —Enable IPX ipx enable RequiredDisabled by default.Enter VLAN interface view interface Vlan-interfacevlan-id —Configure an IPX networknumber for the VLANinterfaceipx network networkRequiredBy default, the systemdoes not assign networknumbers to VLANinterfaces. That is, IPX isdisabled on all VLANinterfaces.Exit VLAN interface view quit —Configure IPX staticroutesipx route-static networknetwork.node[ preference value ] [ tickticks hop hops ]OptionalThe IPX static routeswhose destinationnetwork number is0xFFFFFFFE are defaultroutes.
