Operation Manual – VLANH3C S7500 Series Ethernet Switches Chapter 2 VLAN Configuration2-5Note:z To convert a Trunk port into a Hybrid port (or vice versa), you need to use theAccess port as a medium. For example, the Trunk port has to be configured as anAccess port first and then a Hybrid port.z The default VLAN IDs of the Trunk ports on the local and peer devices must be thesame. Otherwise, packets cannot be transmitted properly.2.2.3 Configuring a Hybrid-Port-Based VLANA Hybrid port may belong to multiple VLANs, and this configuration can only beperformed in Ethernet port view.Follow these steps to configure the Hybrid-port-based VLAN:To do… Use the command… RemarksEnter system view system-view —Enter Ethernet port view interface interface-typeinterface-number —Configure the port linktype as Hybrid port link-type hybrid RequiredAllow the specified VLANsto pass through thecurrent Hybrid portport hybrid vlanvlan-id-list { tagged |untagged }RequiredBy default, all Hybrid portsonly allow packets ofVLAN 1 to pass.Configure the defaultVLAN of the Hybrid portport hybrid pvid vlanvlan-idOptionalVLAN 1 is the default bydefaultNote:z To configure a Trunk port into a Hybrid port (or vice versa), you need to use theAccess port as a medium. For example, the Trunk port has to be configured as anAccess port first and then a Hybrid port.z Ensure that the VLANs already exist before configuring them to pass through aHybrid port.z The default VLAN IDs of the Hybrid ports on the local and the peer devices must bethe same. Otherwise, packets cannot be transmitted properly.
