9-3Installing the SCSI Driver for Windows NT 4.08 To add other host adapters that are not part of the Ultra320Family, press S and repeat from Step 5 for each additionaladapter and insert the appropriate driver disk. The AdaptecUltra320 Family host adapters use the same driver; it is notnecessary to install the driver again.9 Press Enter to continue with the Windows NT 4.0 operatingsystem setup. Follow the instructions on-screen and in theWindows NT 4.0 documentation to complete the installation.Completing a Fresh Windows NT 4.0 Installation From CD1 Insert the Windows NT 4.0 CD into the CD-ROM drive.2 Start your system. Press the F6 key when you see the followingmessage:Setup is inspecting your computer’s hardware configuration...If you do not see this message, your system may not be setup toboot from a CD. You will need to install from floppy disks. SeeCompleting a Fresh Windows NT 4.0 Installation From Floppy Diskon page 9-2.3 When prompted, press S to specify an additional device.4 Press Enter to select Others; insert the Ultra320 disk forWindows in your floppy disk drive.5 Using the arrow keys, select the following driver and pressEnter:Adaptec Ultra320 Family PCI SCSI Controller (NT4.0)6 To add other host adapters that are not part of Ultra320 Family,press S and repeat from Step 4 for each additional adapter andinsert the appropriate driver disk. The Adaptec Ultra320 Familyhost adapters use the same driver; it is not necessary to installthe driver again.7 Press Enter to continue with the Windows NT 4.0 operatingsystem setup. Follow the instructions on-screen and in theWindows NT 4.0 documentation to complete the installation.
