4-5Using the SCSISelect Utility to Manage Arrays Dead—One drive in a RAID 0 array is in failed state ormissing. Building—the drive is a target of an ongoing Rebuildoperation Verifying—checking the data integrity of redundantdata stored on fault-tolerant arraysViewing ArrayTo view an array, select the array and press Enter. A detailed viewof the hard drives will appear. From this window you can see thestatus of the individual hard drives. The status you might see are: Optimal—no defect Building—the drive is a target of an ongoing Rebuild operation Verify—checking the data integrity of redundant data storedon fault-tolerant arraysMissing drive information indicates that a member is missingand the array is not optimalExiting the SCSISelect UtilityTo exit SCSISelect:1 Press Esc until a message prompts you to exit (if you changedany settings, you are prompted to save the changes before youexit).2 At the prompt, select Yes to exit. If prompted, press any key torestart the computer. Any changes you made in SCSISelect takeseffect after the computer restarts.Creating ArraysBefore creating the array, make sure the disks for the array areconnected and installed in your system, then follow these steps:1 Start SCSISelect (Ctrl-A).2 Select Configure/View HostRAID Settings.