E-3Migrating From Adaptec Ultra320 SCSI to HostRAID14 Click Next again. You may be prompted with this warningmessage:“The software you are about to install does not contain a MicrosoftDigital Signature...”Ignore the warning and click Yes to continue.15 When the driver is copied on the hard disk drive, click Finish.16 Click Close on the driver Properties window.17 You will be prompted to restart the computer. Select Yes.The new HostRAID driver will be displayed under SCSI andRAID controllers in the Device Manager.Enabling HostRAID SupportAfter installing the HostRAID driver, you must enable HostRAIDsupport before you can use the RAID features. To enableHostRAID for the boot channel, follow these steps:1 Press Ctrl+A keys simultaneously when the Adaptec BIOSappears.2 Select the channel where your boot drive is connected, thenpress Enter.3 From the Options menu, select Configure/View SCSIController Settings and press Enter.4 From the Configuration menu, select HostRAID and pressEnter.5 From the HostRAID Pop-up menu, select Enabled.6 Press Esc, save change, then Exit.