4-8Adaptec Ultra320 SCSI Cards User’s Guide4 Assign a RAID name by entering up to 15 alphabetic or numericcharacters, then press Enter. The following message appears:Do you want to make this array bootable?5 Select Yes if you want to make the array bootable. The followingmessage appears:Create Array?6 Select Yes. The following message appears:Are you sure?7 Select Yes and press Enter to create a RAID 0 array. After yourarray is created, you will automatically return to the Mainmenu.Creating RAID 1 ArraysThere are two ways to create a RAID 1 array. You can create a newRAID 1 array or you can migrate from an existing single drive to aRAID 1 array. To create a RAID 1 array using either option:1 From the Select RAID Type window, select RAID-1. Select thehard drives you want using the Spacebar to toggle, then pressEnter. The RAID-1 Build Option window appears.2 Select an option and press Enter.The options you can choose are: Create new RAID-1—is the default option. Copy from (11) to (12)—copy from a source drive to a targetdrive if the source is equal to or smaller than the target. Copy from (12) to (11)—copy from a source drive to a targetdrive if the source is equal to or smaller than the target.Note: If a valid partition table or boot block is detected inthe target drive, you will get a warning message that theinformation will be destroyed.