6-4Adaptec Ultra320 SCSI Cards User’s GuideChanging Boot ControllersIf you want to reconnect your bootable hard disk drive from theSCSI controller to the HostRAID controller, you must:1 Start Windows NT 4.0 and install the driver from the AdaptecHostRAID Driver Set disk. See Installing the Driver WhenWindows NT 4.0 is Already Installed on page 6-3.2 Shut down Windows NT 4.0 and turn off your system.3 Switch the bootable hard disk drive from the old SCSI controllerto the HostRAID controller.4 Power on your system.Windows NT 4.0 Installation and ConfigurationNotesIf Windows NT 4.0 Setup HangsDuring Windows NT 4.0 installation, the system may hang whilethe Windows NT 4.0 Setup floppy disk is being used to copy thedevice driver. A workaround is to start from a DOS boot disk,create a DOS partition on the array using fdisk, then installWindows NT 4.0 on the array.Windows NT 4.0 Disk AdministratorWhen creating a new array on a system running underWindows NT 4.0, the array is not listed as usable in theWindows NT 4.0 Disk Administrator until it is initialized. This isnormal Windows NT 4.0 functionality.