8-2Adaptec Ultra320 SCSI Cards User’s GuideIf you are performing a first-time Windows installation, seeInstalling the Driver When Installing Windows on page 8-2. IfWindows is already installed in your system, see Updating theDriver When Windows is Already Installed on page 8-4.Installing the Driver When Installing WindowsFor Windows 2000/2003 and Windows XP, the adpu320.sys driveris not embedded on the Windows Installation CD and must beadded during Windows installation.Installing Windows 2000/2003 and Windows XP (32-bit)1 Create a Windows driver disk. See Appendix D, Creating DriverFloppy Disks for more information.2 Start your system with the Windows CD in the CD-ROM drive.Note: When using a CD-ROM drive to install Windowsfrom the bootable CD, make sure Bootable CD support isenabled in either the system or SCSI BIOS Setup Utility. Ifthese options are not available, boot from the Windowsfloppy disks.3 You may see a message:Press any key to boot from CD.You have five seconds to press a key to boot off the CD.4 Press F6 when this message is displayed:Press F6 if you need to install a third-party SCSI or RAID driver...5 After a brief delay, a message prompts you to install yourdriver. Press S to specify a driver.6 Insert the Windows driver disk created in Step 1 into drive A,and press Enter.7 You are presented with a selection of driver choices. Highlightthe appropriate Windows driver (there should be a specificmark for the icon) and press Enter.8 For Windows Server 2003 only—press S to use the driver onthe floppy disk.
