E-7Migrating From Adaptec Ultra320 SCSI to HostRAID2 At the Welcome to the Found New Hardware Wizard window,select Next.3 Select Install the software automatically (Recommended), thenclick Next.4 You may be prompted with this warning message:“The software you are installing for this hardware: Adaptec xxxxxHostRAID driver has not passed Windows Logo testing...”Ignore the warning and click Continue Anyway.5 Insert the Adaptec Installation CD into the CD-ROM drivewhen prompted, then click OK.6 When the driver is copied on the hard disk drive, click Finish.7 You will be prompted to restart the computer. Select Yes.Note: To migrate the nonboot channel from SCSI to HostRAID,follow the instructions for migrating from a boot channel foryour other channel.Migrating With Windows NT 4.0Installing the HostRAID DriverTo migrate from SCSI to HostRAID with a Windows NT 4.0operating system, follow these steps:1 Start Windows NT 4.0.2 Click on Start=>Settings=>Control Panel.3 In the Control Panel, double-click the SCSI Adapters icon, thenclick on the Drivers tab, then click Add.4 From the Install Driver window, click Have Disk....5 Insert the Adaptec Installation CD into the CD-ROM drive. Ifthe CD automatically opens a welcome screen, click the Exitbutton to close it.6 At the Install From Disk window, click the Browse button andpath D:\drivers\windows\nt4 (where D: is the CD-ROM driveletter). Click Open, then click OK.
