10-3Installing the SCSI Driver for Novell NetWareInstalling the Driver When NetWare is AlreadyInstalledTo update or install the adpu320.ham driver when NetWare isalready installed, follow the instructions in this section. Theprocedures are similar for all versions of NetWare. Procedures thatare specific to a NetWare version are noted when necessary.1 Make a backup copy of the old driver (if it exists) beforeinstalling the new driver.2 Copy the adpu320.ham driver from the Ultra320 FMS driverfloppy disk for NetWare into the server’s startup directory (forexample, c:\nwserver, c:\server.40) on your hard disk. Thisoverwrites any existing version of the driver in the directory.3 If necessary, modify the load command line in the startup.ncf fileso that the proper path to the driver and all appropriatecommand line options are specified. See Loading the Driver atServer Bootup on page 10-4.The correct syntax to load the Ultra320 driver is:load [pathname]adpu320 [options]Command line options are not case sensitive. Placing spacesbetween command line options is required. See Loading theDriver at Server Bootup on page 10-4 for possible values.