E-6Adaptec Ultra320 SCSI Cards User’s Guide13 You may be prompted with this warning message:“The software you are installing for this hardware: Adaptec xxxxxHostRAID driver has not passed Windows Logo testing...”Ignore the warning and click Continue Anyway.14 When the driver is copied on the hard disk drive, click Finish.15 You will be prompted to restart the computer. Select Yes.The new HostRAID driver will be displayed under SCSI andRAID controllers in the Device Manager.Enabling HostRAID SupportAfter installing the HostRAID driver, you must enable HostRAIDsupport before you can use the RAID features. To enableHostRAID for the boot channel, follow these steps:1 Press Ctrl+A keys simultaneously when the Adaptec BIOSappears.2 Select the channel where your boot drive is connected, thenpress Enter.3 From the Options menu, select Configure/View SCSIController Settings and press Enter.4 From the Configuration menu, select HostRAID and pressEnter.5 From the HostRAID Pop-up menu, select Enabled.6 Press Esc, save change, then Exit.Completing the HostRAID Driver InstallationAfter you have installed the HostRAID driver and enabledHostRAID support, you need to complete the installation so thatthe Windows operating system can detect the new enabled driverhardware.To complete your HostRAID driver installation, follow these steps:1 Restart Windows XP.Windows XP will detect the newly enabled HostRAID supportand will prompt you for the HostRAID driver.