9-5Installing the SCSI Driver for Windows NT 4.0Using Advanced Configuration ParametersAdvanced users may use software parameters to alter theconfiguration of the Windows NT 4.0 device drivers supplied byAdaptec. For more information on using advanced configurationparameters, see Appendix C, Using Windows AdvancedConfiguration Parameters.Hot-Plug PCI SupportHot-Plug PCI is supported by the Windows NT 4.0 driveradpu320.sys.Warning: You will need a system that supports Hot-Plug PCIas well as associated Hot-Plug PCI application software inorder for Hot-Plug PCI to work. Do not enable the Hot-PlugPCI feature unless your system is Hot-Plug PCI capable andyou wish to use the Hot-Plug PCI feature. For moreinformation on Hot Plug PCI, refer to your motherboard orsystem documentation.To enable Hot-Plug PCI support in the driver:1 Insert the Adaptec Installation CD into drive D.2 Select Run from the Start menu.3 Type the following, then press Enter:d:\packages\FMS\Windows\driver\winNt40\hotp320.reg4 Click OK.5 Restart your computer.