12-2Adaptec Ultra320 SCSI Cards User’s GuideInstalling the Driver When Installing Solaris 9To install Solaris 9 with an Ultra320 SCSI Host Adapter:1 Start your installation using one of the following: Solaris 9 Configuration Assistant Diskette Solaris 9 Install CD (for Web Jumpstart Installation) Solaris 9 Software (1 of 2 CDs)Wait until the Solaris Device Configuration Assistant screen isdisplayed, then press F4 to add the driver (F4_Add Driver).2 The Install Supplemental Drivers screen is displayed. If youbooted off of the Configuration Assistant diskette, replace itwith the Adaptec driver disk, otherwise, insert the Adaptecdriver disk into the floppy disk drive and press F2(F2_Continue). (See Appendix B, Windows Error Messages forinformation on creating driver floppy disks.)3 On the Select Solaris System Version window, select Solaris OS2.9 by pressing the Spacebar, then press F2 (F2_Continue).4 On the Loading Supplemental Driver Software window, youwill see a progress bar displaying the status of adpu320.itu beingloaded into memory. Then the Continue Supplemental DriverInstallation window is displyed. If you need to install otherdrivers, insert them into the floppy disk drive and press F2(F2_Continue); otherwise press F4 (F4_Done).5 The Identified Device Drivers window is displayed. Theadpu320 should be one of the identified drivers. Press F2(F2_Continue). The Solaris Device Configuration Assistantwindow will be displayed.If you booted off the Configuration Assistant diskette, reinsert itinto the floppy disk drive and press F2. Otherwise, just Press F2(F2_Continue). You will see the Scanning Devices window with astatus bar, then the Identified Devices window will bedisplayed. Among the identified devices, look for the lineAdaptec SCSI Card 39320A - Ultra320 SCSI or Adaptec SCSI Card39320 - Ultra320 SCSI. If it is not there, please check that youhave the correct driver and SCSI controller.
