E-4Adaptec Ultra320 SCSI Cards User’s GuideCompleting the HostRAID Driver InstallationAfter you have installed the HostRAID driver and enabledHostRAID support, you need to complete the installation so thatthe Windows operating system can detect the new enabled driverhardware.To complete your HostRAID driver installation, follow these steps:1 Restart Windows 2000.Windows 2000 will detect the newly enabled HostRAIDsupport and will prompt you for the HostRAID driver.2 At the Welcome to the Found New Hardware Wizard window,select Next.3 At the Install Hardware Device Drivers window, select Searchfor a suitable driver for my device, then click Next.4 At the Locate Driver Files window, click Next .5 Click Next again. You may be prompted with this warningmessage:“The software you are about to install does not contain a Microsoftdigital signature...”Ignore the warning and click Yes to continue.6 Insert the Adaptec Installation CD into the CD-ROM drivewhen prompted, then click OK.7 When the driver is copied on the hard disk drive, click Finish.8 You will be prompted to restart the computer. Select Yes.Note: To migrate the nonboot channel from SCSI to HostRAID,follow the instructions for migrating from a boot channel foryour other channel.