3-9Configuring the Adaptec SCSI Card with SCSISelectExtended INT 13 Translation for DOS Drives > 1 GByte—(Default:Enabled) When set toEnabled, provides an extendedtranslation scheme for SCSI hard disks with capacities greaterthan 1 GB. This setting is necessary only for current versions ofMS-DOS; it is not required for other operating systems, such asNetWare or UNIX.Caution:Changing the translation scheme destroys all dataon the drive. Be sure to back up your disk drives beforechanging the translation scheme.Post Display Mode—(Default:Verbose)During POST, theamount of information displayed depends on the mode. If youchange this setting, the change automatically applies to bothSCSI channels. The following modes are available:Verbose—The results of the SCSI bus scan are displayed, butthe results of the PCI bus scan are not displayed.Silent—Nothing is displayed about POST, not even theAdaptec banner. However, error messages are displayed ifthere is a problem on the SCSI bus or SCSI devices.Caution:Setting this feature toSilentcompletelydisables the messages displayed by the Adaptec SCSICard during the restart of the system. You will have toremember where in the POST cycle of the BIOS thePress for SCSISelect (TM) Utility!message wasdisplayed, and pressCtrl-Aat that time to get intoSCSISelect. If you pressCtrl-Atoo early or too late, youwill not be able to enter into the cards setup.Diagnostic—The PCI and SCSI bus scan results aredisplayed separately. There is a pause between PCI and SCSIscans.!!