F-3Migrating from HostRAID to Adaptec Ultra320 SCSI14 Click Next again. You may be prompted with this warningmessage:“The software you are about to install does not contain a MicrosoftDigital Signature...”Ignore the warning and click Yes to continue.15 When the driver is copied on the hard disk drive, click Finish.16 You will be prompted to restart the computer. Select Yes.The new Adaptec Ultra320 SCSI driver will be displayed underSCSI and RAID controllers in the Device Manager.Disabling HostRAID SupportAfter installing the Adaptec Ultra320 SCSI driver, you must disableHostRAID support before you can use the SCSI features.Warning: Before you disable HostRAID, for RAID 1, you mustbreak a RAID 1 array. See the following steps for instructions.For RAID 0, you will loose all your data if you try to disableHostRAID.To disable HostRAID, follow these steps:1 Press Ctrl+A keys simultaneously when the Adaptec BIOSappears.2 When your Adaptec Ultra320 SCSI Card appears, press Enter.If you are using a dual channel card, select Channel A, thenpress Enter.3 On any channel containing an array, scroll down and selectConfigure/View HostRAID Settings.4 Select the array by scrolling to it and pressing Enter. This willdisplay the members of that array.5 Press the D key to delete the selected array. When prompted toconfirm deletion of the array, select Yes.6 At the Deleting Information window, select None and pressEnter.7 When prompted, select Yes to continue.