11-7Installing the SCSI Driver for UnixWare, OpenServer, and Open Unix2 When the kernel has been built, type the following and pressEnter after each line (0 in -g0 is zero, not the letter O):cd /etc/conf/cf.dcp unix /stand/unixcd /shutdown -g03 Type y and press Enter when the computer asks if you reallywant to shut down. System Is Down should appear on the screen.The UnixWare/Open Unix kernel is now ready for host adapteroperation.Boot the New KernelTo reboot the computer with the new kernel:1 Follow the on-screen instructions (usually by pressing Enter) toreboot your computer.2 Check the bootup messages to verify that all your installed SCSIdevices are listed.If some or all of your installed SCSI devices do not appear atthis time, your SCSI cables may be loose, or the SCSI devicesetup may not be complete. If so, go back and correct anyproblems before proceeding.3 Wait for UnixWare/Open Unix to complete bootup with thenew kernel.Refer to Troubleshooting on page 11-11 if the computer crashes orif panic (UnixWare/Open Unix ) messages appear duringbootup.The updated driver for UnixWare/Open Unix should now beready to use.
