4-9Using the SCSISelect Utility to Manage Arrays3 After entering your options, if a partition exists on any of theselected drives, you will get a message that the partition will bedeleted. Assign a RAID name by entering up to 15 alphabetic ornumeric characters, then press Enter. The following messageappears:Do you want to make this array bootable?4 Select Yes if you want to make the array bootable. The followingmessage appears:Create Array?5 Select Yes. The following message appears:Are you sure?6 Select Yes and press Enter to create a RAID 1 array. If you selectNo, the RAID creation will terminate and you will return to theMain menu.After your array is created, the progress bar will appearshowing the percentage completed in the create process. If forany reason you want to stop the build process and return to theMain menu, press Esc. You may continue the build process byselecting the Rebuild function later.Note: You might not be able to use the array if the build hasnot been entirely completed.To add a spare to an existing RAID 1 array, see Adding a SpareDrive on page 4-11.Creating RAID 10 ArraysTo create a RAID 10 array:1 From the Select RAID Type menu, select RAID-10 and pressEnter.2 Select the hard drives you want to use and press Enter.3 Select the stripe size and press Enter. You can select from 16K,32K, or 64K.