9-7Installing the SCSI Driver for Windows NT 4.0To eliminate the Warning message, you must update the WindowsNT 4.0 software configuration, described as follows:Removing a Host Adapter in Windows NT 4.01 From the Control Panel, double-click the SCSI Adapters icon.2 Click the Drivers tab.3 Using the arrow keys select the following driver:Adaptec Ultra320 Family PCI SCSI Controller (NT 4.0)4 Click the Remove button.5 If you are sure you are removing the correct host adapter type,click Yes.6 Click Yes to restart the computer and initialize changes. ClickNo to return to the SCSI Adapters window.Note: Windows NT 4.0 Setup does not delete the device driverfrom your system disk; it only updates Windows NT 4.0software configuration information so that the device driveris no longer loaded during system startup.Swapping a Host AdapterSwapping an Ultra320 Family host adapter for a non-Ultra320 hostadapter is similar to the procedure for adding a host adapter. Theimportant distinction is that you make all software configurationchanges while Windows NT 4.0 is running and before you makethe hardware changes.Note: If you do not install the driver that comes with the newhost adapter, it may result in a Windows NT 4.0 boot failure.
