Cabletron Systems Cabletron CyberSWITCH CSX5500 User Manual

Also see for CyberSWITCH 5500: Quick start Manual

Contents

Central Site Remote Access Switch 187CONFIGURING D EVICE L EVEL DATABASESOn-node Device EntriesIf you select PVC, the list of available PVCs are displayed. The LCN of the selected PVC andthe X.25 Access Name are stored in the Device Table to bind the device to a particular virtualcircuit configuration:If you select SVC, you must enter the X.121 address of the remote DTE. You need the remoteDTE address to make the X.25 call to the proper remote device.8. For Digital Modem devices:Begin by selecting Digital Modem from the Device Table Menu. The following menu will thenbe displayed:a. No change is necessary for Line Protocol. At this time, only PPP is available.b. No change is necessary for Baud Rate. At this time, only Auto is available.c. Select the line’s bearer capabilities.d. Enter the phone number for this device.Note: For detailed instructions on setting up your CyberSWITCH for Digital Modem usage,refer to Configuring Other Advanced Options.Select the type of the Virtual Circuit1) Permanent Virtual Circuit (PVC)2) Switched Virtual Circuit (SVC) [default 2]: 1Current Permanent Virtual Circuits defined for X.25 Access #1, ’VMAX25’:id Type LCN Protocol-- ---- ---- --------1 PVC 1 RFC8772 PVC 2 RFC877Id of Virtual Circuit to associate with device "vma",or to cancel? 1Select the type of the Virtual Circuit1) Permanent Virtual Circuit (PVC)2) Switched Virtual Circuit (SVC) [default 2]: 2Enter the X.121 Address of the Remote DTEor press to cancel? 9987654321Device MODEM Menu: (device = "DAN")1) Line Protocol "PPP (Point to Point Protocol)"2) Baud Rate "Auto"3) Bearer Capabilities "Speech"4) Dial Out Phone Number(s) ""Select function from above or for previous menu: