Central Site Remote Access Switch 443VERIFYING ROUTING P ROTOCOLSIP Routing Operational?3. Determine if a local IP Host A has learned the route to 192.1.1.0 from System A. On IP Host Atype:netstat -r If the route to 192.1.10 is displayed, the IP RIP output processing is operational.4. If the route is NOT displayed, try the following:a. Using theipnetif Manage Mode command, verify that the IP RIP Send Control is set toa RIP version that the IP Host can understand.b. If the command shows Do Not Send, the IP RIP output processing is disabled on theinterface. Correct the RIP Send Control configuration using CFGEDIT.c. If the command shows an improper version of RIP, correct the RIP Send Control to theproper RIP version that the IP Host can understand.5. Enter theip rip stats administrative console command. Look for theIfStatSentResponses counter for the interface, which shows the number of RIP updatemessages sent on the interface.a. If the counter is 0, enter theip rip send administrative console command to force theRIP update message to be sent immediately.b. Reissue theip rip stats command.c. If the counter is still 0, there is an unexpected condition present within the CyberSWITCHsoftware. Contact Customer Support.6. If the RIP Send Control is set to “RIP Version 1” or “RIP Version 1 Compatibility,” use ManageMode to verify that the transmit broadcast address on the interface is set to a proper addressthat the IP Host can receive (through issuing theipnetif Manage Mode command).7. If the transmit broadcast address is not set properly, use CFGEDIT to correct it.8. Check the IP Host and ensure that it is set up to learn route information via RIP.IP RIP I NPUT PROCESSING ON A LAN INTERFACETo verify that IP RIP Input Processing (routes learning) is properly operational on a LAN interface,IP RIP processing must be successfully initialized. Also, a local IP router must be connected to thelocal LAN port on the system and capable of propagating routes information via RIP.Below is an example of a configuration used to verify IP RIP input processing on a LAN interface.It uses IP addresses specified to the example. Substitute the IP addresses of your network when youperform the verification steps. It also uses thenetstat command. Thenetstat commanddisplays the IP routing table of the system. Substitute the equivalent command on your IP router.
