Cabletron Systems Cabletron CyberSWITCH CSX5500 User Manual

Also see for CyberSWITCH 5500: Quick start Manual

Contents

Central Site Remote Access Switch 427V ERIFYING THE B ASE SYSTEMIP Host Mode3. Telnet from the client PC into the central site. For example, telnet to 100.0.0.1, port 7003. Followthe normal user level authentication process.4. Once again, determine if the client PC can ping the Service Server. On the Client PC, type:ping 100.0.0.2 If the ping is successful, then multi-level security is operational.5. If the ping is unsuccessful, try the following:a. Ensure that the remote device can ping across the network with User Level AuthenticationDISABLED.b. Disconnect the call if it is still up.c. Check to see if the User Level Security database and server are properly configured. Ensurethat the user ID and password are accurate.d. If the problem is still not resolved, contact Customer Support.IP H OST M ODEIP HOST I NITIALIZED ?V ERIFICATIONIf you have configured the IP feature in the Host mode:1. Determine if IP Host has been initialized by viewing the system messages. To view themessages, enter the following command:dr 2. Look for the following IP message among the system messages:[IP] IP Host is initialized successfully3. For the IP Interface that has been configured, the following interface initialization messageshould be displayed among the system messages:[IP] Network initialized successfully on ddd.ddd.ddd.dddNote: Other messages may also be displayed with the IP router initialization messages.If you see these IP host initialization messages, then the IP host is operational.4. If the system does not display the correct IP Host Initialization messages, or, instead, displaysthe following message:[IP] IP Router is initialized successfullya. Check the configuration. Make sure that the IP feature is enabled.b. Make sure that the operating mode is set to Host rather than Router.IP HOST M ODE OPERATIONAL ?To verify that IP Host mode feature is properly operational, a remote IP Host must be operationaland available to initiate WAN connections via a remote bridge device. Also, a local IP host must beconnected to the local LAN port on the CyberSWITCH.