| 
USER’S GUIDE526 CyberSWITCHReceived charge amount - The system has received an advice of charge from the network for the call just disconnected. Thecharge for this call is indicated in the charge amount parameter.Received CLLM while PVC for DLCI in unexpected state A CLLM message was received indicating that a network condition should be expected for the PVCassociated with the indicated DLCI. However, this PVC is in the indicated state and as such isalready acting on a previous network condition notification.Remote peer ID discrepancyThe On-node Device Table and the remote end of the connection disagree on the identity of theremote end. Check configuration, and then reboot the remote device. If problem persists, contactyour Distributor or Customer Support.Replace Lithium Battery: Contact your RepresentativeIf this message is displayed in the log messages, contact your Distributor or Customer Supportbefore you power off your system.Requested channel not available - The system has attempted a call using a channel on the indicated line that was not available. Thecall will be retried over a different line if possible.Reserved signalThis message is informational only and is used to indicate additional details on the received in the “call progress” information message.Resmem_gettotal: Enabled size , greater than Checksize for Internal error that should be reported to Customer Support.ResMem_Malloc failure for subsystem (size=, type=, class=, ra=)ResMem_Malloc Size too large for subsystem (type=, class=ra=)ResMem_Malloc Device not registered (ra=)ResMem_Obtainable Device not registered (ra=)Any of the above three messages indicate that an internal error has occurred that should bereported to Customer Support. The system will restart when this error occurs.Retrying download of DM card in slot in secondsThe system has failed on previous attempts to initialize the Digital Modem card. The system willretry a specific number of times before logging a failure message. Check the hardware and softwareconfiguration, reseat the card in its ISA slot, and/or check the MVIP cabling. If the problem persists,contact your Distributor or Customer Support.Rx Channel Inactivity DetectedNo keep-alive frames have been received over an active connection to a remote system. Thisindicates that the connection or the remote node has failed (or been powered-off) without anindication of the failure from the network. If the event continues, contact your Distributor orCustomer Support. |
