| 
Central Site Remote Access Switch 499SYSTEM M ESSAGESSystem Message SummaryCFGEDIT. If the board is configured properly, and the message still appears, contact yourDistributor or Customer Support.DM card in slot will not come out of resetThere are problems initializing the board. Contact your Distributor or Customer Support.DM upgrade timeout. Board=, Modem=DM upgrade error during download. Modem says = xxxDM upgrade no response at start. Board=, Modem=DM upgrade flash erase failed. Board=, Modem=DM upgrade no response at end. Board=, Modem=There were problems while attempting to update the firmware of the specified modem due toeither a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or checkthe MVIP cabling. If problems persist, contact your Distributor or Customer Support.DM upgrade started. Board=, Modem=The system has begun to update the firmware of the specified modem on the Digital Modem card.Watch for subsequent log messages to ensure the update is successful.DM session in unknown upgrade state. Board=, Modem=There were problems while attempting to update the firmware of the specified modem due toeither a corrupt firmware file or hardware problems. Contact your Distributor or CustomerSupport.DM upgrade success. Board=, Modem=The system has successfully updated the firmware of the specified modem on the Digital Modemcard.DM: TimeSlot driver circuit id already in use on CREATEDM: No TimeSlot driver circuits available for CREATEDM: TimeSlot driver circuit id not in use on REMOVEDM: TimeSlot driver circuit id not found on REMOVEThere were problems related to the Digital Modem’s use of the TDM bus. Contact your Distributoror Customer Support.Downloading Bootstrap to DM card in slot Informational message stating that the system is attempting to initialize a Digital Modem card.Watch for subsequent log messages to ensure the initialization is successful.Downloading DM card in slot with operational softwareInformational message displayed during a successful initialization. Watch for subsequent logmessages to ensure the initialization is successful.Downloading WAN card in slot with operational softwareInformational message during a successful system initialization. The status of the downloadprocess for WAN card in slot is identified. This should be reported after the “Bootstrapcame alive...” message for a given adapter.DSL test failed to establish Layer 1, port=During power up, all WAN lines undergo a test to see if Layer 1 can be established. This messageindicates a test failure. Check the wiring. If correct, contact your phone company. |
